Engraving machine manufacturer analysis platform suction insufficient solution

In the use of the engraving machine manufacturer, there may be a phenomenon that the suction table has no suction and cannot absorb the plate. What is the cause of this problem? How to solve it? Today, we introduce the solution for the woodworking engraving machine table not to be adsorbed:

1. Is the motor line voltage normal?

2. Whether the water circulation air pump adds less water, whether the motor is stuck or not, and the rotating shaft of the motor fan protection net is removed;

3. The filter in the vacuum pump is blocked and cleaned;

4. The surface of the counter or pipe is trimmed by air leakage;

5, positive and negative exchange motor, any two lines change the direction of the motor.

The woodworking engraving machine uses vacuum adsorption to fix the plate, which not only can be firmly fixed, but also does not move and engrave the misalignment, etc., and the plate is fixed relative to the splint, which can save the plate and engrave to the edge of the plate, saving time and effort.

What causes the limit trigger of woodworking engraving machine

The woodworking engraving machine will trigger the limit during long-term use. What is the cause? How can we solve this problem? ?
Generally speaking, when this phenomenon occurs, the woodworking engraving machine may be beyond the scope of engraving, so we have to set all the parameters in the wood engraving machine engraving software. In addition, when we operate this machine, we need to fix the engraving range, then add the parameters, it is also important to check the limit switch of the machine. After such an operation method, the problem of the machine failure can be quickly solved. If you still have not solved this problem, you can always contact the professionals of Guangzhou Education, we will definitely solve the problem for you.